Home » Products » Ball Mill Head Rubber Lifter Bar
  • Ball Mill Head Rubber Lifter Bar
  • Ball Mill Head Rubber Lifter Bar

Ball Mill Head Rubber Lifter Bar


Ball mill is the key equipment for grinding materials in the manufacture industries, such as cement, silicate, new building material, refractory material, fertilizer, ferrous metal, nonferrous metal and glass ceramics and can be used for the dry and wet grinding for all kinds of ores and other grind-able materials.
There is a mill head equipped in front of a mill shell, and when material need to feed in to the mill, the mill head need to be lifted, at this time a rubber lift bar (Mill Lifter Liner) is needed.
As a liner, the lift bar is used to protect ball mill head from direct impact and friction by grinding medium and material. This kind of Mill Lifter Liner is widely used in all kinds of working condition to increase grinding efficiency and production and reduce consumption of metal. We are able to provide custom this lifter bar conforming to customers’ requirements.

Specifications of Rubber Lift Bar for Ball Mill Head

140-110 Lifter Bar 140-135 Lifter Bar 165-135 Lifter Bar 165-160 Lifter Bar 165-160 Composite Lifter Bar
165 Lifter Bar 210-180 Lifter Bar 210-220 Lifter Bar 210-300 Lifter Bar 210-400 Lifter Bar

Advantages of Rubber Lift Bar for Grinding Mill

1. Our ball mill head lifter bar (Mill Lifter Liner) has long service life.
2. This rubber lifter bar adopts special formula and high-pressure vulcanization process, its well wear resistance sharp increase the service life and its service life is about 1.5 to 2 times of steel liner plate. Its own flexible feature sharply reduces the intense impact.
3. Through special technical formula, it has a good corrosion resistance.

Use Tips of Rubber Lift Bar for Grinding Mill

1. Install the filling segment on the joint part of the head and shell, and then put the head liner (Mill Lifter Liner) on the filling segment.
2. Wear the fill bar of the end T-bolt and press them on the edge of the head liner.
3. Put a piece of end plate (Mill Lifter Liner), buckle on T-bolt nut, but don’t lock it at this time.
4. Repeat the above steps until you installed a part of the head liner and lifter bar, and then you should put the side ear of the center ring insert the back of the head liner and lifter bar.
5. At last lock the T-bolt nut and rotate cylinder, then you can install the rest part as the above steps.